Archives

Jack Stand Holder

September 11, 2014 2:53 pm Published by Comments Off on Jack Stand Holder

This Jack Stand Holder holds 2 grinders with or without guards, 4 two-hole pins, 2 squares, 1 hammer, 1 remote box, and levels. This Jack Stand Holder has a quick attach hub that clamps to the jack stand tube itself which allows the user to move or remove the Jack Stand Holder without removing fabrication or the jack stand head. It has an arm that swivels 180 degrees and folds up for easy storage. This tool is perfect for in-shop or location fabrication by providing quick access to all the equipment needed while fabricating.

Quick Clamp

April 17, 2014 2:15 am Published by Comments Off on Quick Clamp

This Quick Clamp attaches to the C.B.T. Roll Out Wheel quickly and easily by bolting through the bolt holes and into slots on the Roll Out Wheel. When used with a chain clamp, the Quick Clamp allows the welder to attach pipe to the C.B.T. Roll Out Wheel to perform fab welds not requiring flanges.